'fatal page fault' with 3/30/00 floppy26.fs

[Jeremie Kass <jeremie@umich.edu>]

Trying to install from the 3/30 snapshot floppy26.fs onto a IBM Thinkpad
240 with a Dayna Communicard E 16bit 10mbit PCMCIA card.

floppy boots fine, detects ne3, then:

pcmcia1 at pcic0 controller 0 socket 1
fatal page fault in supervisor mode
trap type 6 code 0 eip e02295be cs 8 eflags 10287 cr2 0 cpl 0
panic: trap

The operating system has halted.
Please press any key to reboot.


Without the ethernet card, it boots fine. Then, if I put the card in
at the 'Enter pathname of shell or RETURN for sh:' prompt, it gets
detected fine.


[goes thru installation fine, booting off floppy drive, did boot
wd0a:/bsd]

after detecting the NIC it gets:
pcmcia1 at pcic0 controller 0 socket 1
kernel: page fault trap, code=0
Stopped at _strcmp+0xe:	movb	0(%eax),%cl
ddb> trace
_strcmp(e07c6000,e0363140,e04a659c,e07c6600,e0363140) at _strcmp+0xe
_pcmcia_submatch(e07c6000,e0363140,e04a659c,e0352305,e036294e) at
_pcmcia_submatch+0x33

(rest of the trace available if needed).

And again, if I boot without the PCMCIA card, it boots fine.

 - Jeremie