Driver for DaynaPORT E/II-3

[Stan <stanb@mminternet.com>]

Hi, folks.

I was wondering what driver needs to be added to the 2.7 kernel for my
DaynaPORT E/II-3 (10baseT, AUI, BNC).  It appears to have the Natl.
Semiconductor 8390 chip on it.  The card is a "Rev B" (if that matters).
 Note that I'm using this card in a Macintosh Centris 650, which has
built-in Ethernet, for which the sn0 interface works just great. 
Perhaps I just need to add support for an additional sn (sn1) interface?

Here is the message I get:
nubus0: slotc: EtherNet card (Vendor: Dayna Communications Inc., Part:
SMALL-ALABAMA-ROM Type: 0004 0001 0115 0100 not configured

Thanks for any assistance you can give me.

-Stan B.