[Fwd: Driver for DaynaPORT E/II-3]

[Stan <stanb@mminternet.com>]

On Thu, 14 Sep 2000 at 10:43:06 I wrote:
> Hi, folks.
> 
> I was wondering what driver needs to be added to the 2.7 kernel for my
> DaynaPORT E/II-3 (10baseT, AUI, BNC).  It appears to have the Natl.
> Semiconductor 8390 chip on it.  The card is a "Rev B" (if that matters).
>  Note that I'm using this card in a Macintosh Centris 650, which has
> built-in Ethernet, for which the sn0 interface works just great. 
> Perhaps I just need to add support for an additional sn (sn1) interface?
> 
> Here is the message I get:
> nubus0: slotc: EtherNet card (Vendor: Dayna Communications Inc., Part:
> SMALL-ALABAMA-ROM Type: 0004 0001 0115 0100 not configured
> 
> Thanks for any assistance you can give me.
> 
> -Stan B.

Anyone have any ideas?  If not, recommendations on an alternative card? 
Or perhaps I just bag this and switch to x86...

Thanks,
Stan B.