[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: 2.8 stable hangs :(

To: Brice Gensburger <bgensburger@kaptech.com>
Subject: Re: 2.8 stable hangs :(
From: Joseph Mallett <jmallett@newgold.net>
Date: Mon, 2 Apr 2001 11:37:09 -0400 (EDT)
Cc: misc@openbsd.org
The only time I've had that happen is when I removed a PS/2 device or
something. Console was like dead totally, but when I ssh'd over, I could
write to the terminal, etc.

I actually left it up for 5 days like that because I had to keep serving a
site.

/joseph

--
Joseph Mallett           Security Specialist
+1 919 349 2976              www.newgold.net
josephm@ohsmeg.com      jmallett@newgold.net

xMach: The proactively unbloated microkernel
4.4BSD-like operating system.  www.xMach.org

On Mon, 2 Apr 2001, Brice Gensburger wrote:

> At 19:08 02/04/01 +0400, you wrote:
> (...)
> 
> >i.e. i can successfully ping eth interface or establish tcp connection, 
> >but nothing else.
> >System does not respond even from console!
> >And nothing in logs. They just stop.
> >So, i can only use `reset' button :(
> 
> hey, funny, i just had the same today.
> the machine just hanged.
> but the forwarding between interfaces was still working when i had to 
> reboot the box..
> 
> i couldn't SSH into it, so tried the port from another box
> 
> nmap -p 22 10.60.100.3
> 
> Starting nmap V. 2.53 by fyodor@insecure.org ( www.insecure.org/nmap/ )
> Interesting ports on Lithium.psi1.kaptech.net (10.60.100.3):
> Port       State       Service
> 22/tcp     filtered    ssh
> 
> Nmap run completed -- 1 IP address (1 host up) scanned in 3 seconds
> 
> 
> 
> (ssh does accept connections from everywhere, so this was strange..)
> but NAT and ip forwarding was still working (it's my gateway..)
> i had to reboot it, and the logs show
> well
> nothing.
> there's a 10h hole in it..
> 
> (from /var/log/messages.0.gz: )
> 
> Apr  2 04:29:25 lithium /bsd: arplookup: unable to enter address for 10.1.0.69
> Apr  2 04:33:25 lithium last message repeated 3 times
> Apr  2 14:54:53 lithium syslogd: restart
> Apr  2 14:54:53 lithium /bsd: OpenBSD 2.8-stable (KAPTECH-OBSD-FW) #1: Fri 
> Mar 30 13:55:03 CEST 2001
> Apr  2 14:54:53 lithium 
> /bsd:     root@lithium:/usr/src/sys/arch/i386/compile/KAPTECH-OBSD-FW
> Apr  2 14:54:53 lithium /bsd: cpu0: Intel Pentium III (Coppermine) 
> ("GenuineIntel" 686-class) 698 MHz
> Apr  2 14:54:53 lithium /bsd: cpu0: 
> FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SYS,MTRR,PGE,MCA,CMOV,PAT,PSE36,SER,MMX,FXSR,SIMD
> Apr  2 14:54:53 lithium /bsd: real mem  = 535146496 (522604K)
> Apr  2 14:54:53 lithium /bsd: avail mem = 493293568 (481732K)
> Apr  2 14:54:53 lithium /bsd: using 5689 buffers containing 26861568 bytes 
> (26232K) of memory
> Apr  2 14:54:53 lithium /bsd: mainbus0 (root)
> Apr  2 14:54:53 lithium /bsd: bios0 at mainbus0: AT/286+(00) BIOS, date 
> 02/10/00, BIOS32 rev. 0 @ 0xfda74
> Apr  2 14:54:53 lithium /bsd: apm0 at bios0: Power Management spec V1.2 
> (BIOS mgmt disabled)
> Apr  2 14:54:53 lithium /bsd: apm0: AC on, battery charge unknown
> Apr  2 14:54:53 lithium /bsd: pcibios0 at bios0: rev. 2.1 found at 
> 0xf0000[0x10000]
> Apr  2 14:54:53 lithium /bsd: pcibios0: PCI IRQ Routing Table rev. 1.0 
> found at 0xf31d0, size 192 bytes (10 entries)
> Apr  2 14:54:53 lithium /bsd: pcibios0: PCI Interrupt Router at 000:31:0 
> ("Intel 82371FB (Triton) PCI-ISA" rev 0x00)
> Apr  2 14:54:53 lithium /bsd: pcibios0: PCI bus #1 is the last bus
> Apr  2 14:54:53 lithium /bsd: pci0 at mainbus0 bus 0: configuration mode 1 
> (no bios)
> Apr  2 14:54:53 lithium /bsd: pchb0 at pci0 dev 0 function 0 "Intel 82810E" 
> rev 0x03: rng active, 8Kb/sec
> Apr  2 14:54:53 lithium /bsd: "Intel 82810E Graphics" rev 0x03 at pci0 dev 
> 1 function 0 not configured
> Apr  2 14:54:53 lithium /bsd: ppb0 at pci0 dev 30 function 0 "Intel 82801AA 
> Hub-to-PCI" rev 0x02
> Apr  2 14:54:53 lithium /bsd: pci1 at ppb0 bus 1
> Apr  2 14:54:53 lithium /bsd: fxp0 at pci1 dev 1 function 0 "Intel 82557" 
> rev 0x08: irq 9, address 00:03:47:07:30:92
> Apr  2 14:54:53 lithium /bsd: inphy0 at fxp0 phy 1: i82555 10/100 media 
> interface, rev. 4
> Apr  2 14:54:53 lithium /bsd: "Ensoniq AudioPCI97" rev 0x06 at pci1 dev 7 
> function 0 not configured
> Apr  2 14:54:53 lithium /bsd: xl0 at pci1 dev 10 function 0 "3Com 3c905B 
> 100Base-TX" rev 0x30: irq 11 address 00:01:02:2b:50:13
> Apr  2 14:54:53 lithium /bsd: exphy0 at xl0 phy 24: 3Com internal media 
> interface
> Apr  2 14:54:53 lithium /bsd: xl1 at pci1 dev 11 function 0 "3Com 3c905C 
> 100Base-TX" rev 0x74: irq 9 address 00:01:02:da:e8:80
> Apr  2 14:54:53 lithium /bsd: exphy1 at xl1 phy 24: Broadcom 3C905C 
> internal PHY, rev. 6
> Apr  2 14:54:53 lithium /bsd: pcib0 at pci0 dev 31 function 0 "Intel 
> 82801AA LPC Interface" rev 0x02
> Apr  2 14:54:53 lithium /bsd: pciide0 at pci0 dev 31 function 1 "Intel 
> 82801AA IDE" rev 0x02: DMA, channel 0 wired to compatibility, channel 1 
> wired to compatibility
> Apr  2 14:54:53 lithium /bsd: wd0 at pciide0 channel 0 drive 0: <WDC 
> WD100EB-00BHF0>
> Apr  2 14:54:53 lithium /bsd: wd0: can use 32-bit, PIO mode 4, DMA mode 2, 
> Ultra-DMA mode 4
> Apr  2 14:54:53 lithium /bsd: wd0: 16-sector PIO, LBA, 9541MB, 16383 cyl, 
> 16 head, 63 sec, 19541088 sectors
> Apr  2 14:54:53 lithium /bsd: pciide0: channel 0 interrupting at irq 14
> Apr  2 14:54:53 lithium /bsd: wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA 
> mode 4 (using DMA data transfers)
> Apr  2 14:54:53 lithium /bsd: atapiscsi at pciide0 channel 1 not configured
> Apr  2 14:54:53 lithium /bsd: "Intel 82801AA USB" rev 0x02 at pci0 dev 31 
> function 2 not configured
> Apr  2 14:54:53 lithium /bsd: "Intel 82801AA SMBus" rev 0x02 at pci0 dev 31 
> function 3 not configured
> Apr  2 14:54:53 lithium /bsd: isa0 at pcib0
> Apr  2 14:54:53 lithium /bsd: isadma0 at isa0
> Apr  2 14:54:53 lithium /bsd: pcppi0 at isa0 port 0x61
> Apr  2 14:54:53 lithium /bsd: sysbeep0 at pcppi0
> Apr  2 14:54:53 lithium /bsd: lpt0 at isa0 port 0x378/4 irq 7
> Apr  2 14:54:53 lithium /bsd: npx0 at isa0 port 0xf0/16: using exception 16
> Apr  2 14:54:53 lithium /bsd: pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 
> 16 byte fifo
> Apr  2 14:54:53 lithium /bsd: pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 
> 16 byte fifo
> Apr  2 14:54:53 lithium /bsd: vt0 at isa0 port 0x60/16 irq 1: vga 80 col, 
> color, 8 scr, mf2-kbd
> Apr  2 14:54:53 lithium /bsd: pms0 at vt0 irq 12
> Apr  2 14:54:53 lithium /bsd: fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
> Apr  2 14:54:53 lithium /bsd: fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 
> 18 sec
> Apr  2 14:54:53 lithium /bsd: biomask 4040 netmask 4a40 ttymask 5ac2
> Apr  2 14:54:53 lithium /bsd: pctr: 686-class user-level performance 
> counters enabled
> Apr  2 14:54:53 lithium /bsd: mtrr: Pentium Pro MTRR support
> Apr  2 14:54:53 lithium /bsd: dkcsum: wd0 matched BIOS disk 80
> Apr  2 14:54:53 lithium /bsd: root on wd0a
> Apr  2 14:54:53 lithium /bsd: rootdev=0x0 rrootdev=0x300 rawdev=0x302
> Apr  2 14:54:53 lithium /bsd: WARNING: / was not properly unmounted
> Apr  2 14:54:53 lithium /bsd: fxp0: DAD detected duplicate IPv6 address 
> fe80:0001::0203:47ff:fe07:3092: 4 NS, 0 NA
> Apr  2 14:54:53 lithium /bsd: fxp0: DAD complete for 
> fe80:0001::0203:47ff:fe07:3092 - duplicate found
> Apr  2 14:54:53 lithium /bsd: fxp0: manual intervention required
> Apr  2 14:54:53 lithium savecore: no core dump
> Apr  2 14:54:55 lithium ntpd[26627]: xntpd 3-5.93e Tue Jan 23 11:50:23 CET 
> 2001 (1)
> Apr  2 14:54:55 lithium ntpd[26627]: tickadj = 5, tick = 10000, tvu_maxslew 
> = 495, est. hz = 100
> 
> >*default host=cvsup.hu.OpenBSD.org
> >#*default host=cvsup.uk.OpenBSD.org
> >*default base=/var
> >*default prefix=/usr
> >*default tag=OPENBSD_2_8
> >*default umask=002
> >*default release=cvs
> >*default delete use-rel-suffix
> 
> 
>
Follow-Ups:
- Re: 2.8 stable hangs :(
  - From: Ken <krice@research.suspicious.org>
References:
- Re: 2.8 stable hangs :(
  - From: Brice Gensburger <bgensburger@kaptech.com>
Prev by Date: Re: 2.8 stable hangs :(
Next by Date: Re: 2.8 stable hangs :(
Prev by thread: Re: 2.8 stable hangs :(
Next by thread: Re: 2.8 stable hangs :(
Index(es):
- Date
- Thread