Re: Realtek Ethernet Problem under 3.1

["Marco Peereboom" <slash@peereboom.us>]

dmesg would help.

Did the interface work before you enabled pf?
If so send the pf logs as well.

----- Original Message -----
From: "James Mclean" <james@adam.com.au>
To: <misc@openbsd.org>
Sent: Monday, June 10, 2002 13:38
Subject: Realtek Ethernet Problem under 3.1


> All,
>
> I finally built my firewall lastnight, via an FTP install of 3.1. Install
> went without a hitch, which is great. Both my ethernet cards were detected
> and setup during install, without a problem.
> Now, I have 2 ethernet cards in the machine, ne3 (realtek 8029) and rl0
> (realtek 8139). The interface ne3 is setup to be the external/internet
> interface, and rl0 the internal interface.
> ifconfig -a displays the devices, with thier correct IP's etc.
>
> Once the box was setup, i enabled forwarding and pf, and tested it. ne3
> works perfectly, returns pings, and can login with ssh fine. If i try to
do
> anything with the rl0 interface, it does not return a ping, or do
anything.
> I have swapped the card with another realtek 8139 chipset card, but this
> card also did the same thing.
>
> The only interface plugged in as I am sitting here is rl0, and the screen
> says this:
> Jun 10 20:59:31 titanium /bsd : arp : attempt to add entry for
> xxx.xxx.xxx.xxx on ne3 by 00:30:80:dc:49:e8 on rl0
> so presumably it is seeing stuff at a different network layer?
>
> the ip (which i have removed) is the gateway that is setup.
>
> Any ideas people? I dont have to do anything else to setup the interface,
do
> I?
>
> Any help would be great!
>
> Cheers
>
> James
>
> (if you need any config files, i will fwd them)