(fwd) Odd atapiscsi cdrom error with Tyan Tiger 200 motherboard

[Darren Bolding <darren@bolding.org>]

Hello,

I seem to be having a very unusual (occasionally intermitent) problem
with OpenBSD 3.0 on my Tyan Tiger 200 (S2505D)

I just upgraded from 2.9 to 3.0, and now I'm having trouble with my cdrom
drive.

On boot, pciide configures bus 1 to compatability (it detects that a cdrom
is attached?)

atapiscsi then takes over, and has some problems-

The unusual thing is that about once in 20 times, this doesn't happen, and 
the cdrom drive worked fine under 2.9.

I noticed that atapiscsi was tweaked under 3.0- has anyone else seen this?

relevant dmesg output below- has anyone else seen this?

Thanks,

--D



pciide0 at pci0 dev 7 function 1 "VIA VT82C571 IDE" rev 0x06: ATA100, channel 0 
configured to compatibility, channel 1 configured to compatibility
wd0 at pciide0 channel 0 drive 0: <WDC WD400BB-00AUA1>
wd0: 16-sector PIO, LBA, 38166MB, 16383 cyl, 16 head, 63 sec, 78165360 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 5
atapiscsi0 at pciide0 channel 1 drive 1
scsibus0 at atapiscsi0: 2 targets
pciide0:1:1: device timeout waiting to send SCSI packet
sd0 at scsibus0 targ 0 lun 0: <, , > SCSI0 0/direct fixed
wdc_atapi_start: not ready, st = 58
pciide0:1:1: device timeout waiting to send SCSI packet
sd0: mode sense (4) returned nonsense; using fictitious geometry
sd0(atapiscsi0:0:0): Check Condition on opcode 0x25
    SENSE KEY: Not Ready
     ASC/ASCQ: Medium Not Present
sd0(atapiscsi0:0:0): could not get size
sd0: 0MB, 0 cyl, 64 head, 32 sec, 512 bytes/sec, 0 sec total
sd0(pciide0:1:1): using PIO mode 4, Ultra-DMA mode 2



-- 
--  Darren Bolding                                 darren@bolding.org  --

----- End forwarded message -----

-- 
--  Darren Bolding                                 darren@bolding.org  --