isakmpd configuration

["jack xiao" <jack_xiao99@hotmail.com>]

Hi,

I am going to set up two IPSec tunnels. One is 192.168.100.0/24 - 10.10.11.0/24, the other is 192.168.100.0/24 - 172.30.1.0/24. The diagram is like the following, 216.95.234.162 and 216.95.234.110 are two VPN gateways.


                                                                                               |--------- 10.10.11.0/24        
192.168.100.0/24-----216.95.234.162-------------------------216.95.234.110
                                                                                               |---------- 172.30.1.0/24

I set in the isakmpd.conf as something like the following,

[Phase 1]
216.95.234.110=  VPN-11

[Phase 2]
Connections=    VPN-12,VPN-22

[VPN-11]
Phase=   1
Transport=  udp
Local-address=  216.95.234.162
Address= 216.95.234.110
Configuration=  Default-main-mode
Authentication=  qqqqqqqq

[VPN-12]
Phase=   2
ISAKMP-peer=  VPN-11
Configuration=  Default-quick-mode
Local-ID=  Net-local-01
Remote-ID= Net-remote-01

[Net-local-01]
ID-type=  IPV4_ADDR_SUBNET
Network=  192.168.100.0
Netmask=  255.255.255.0

[Net-remote-01]
ID-type=  IPV4_ADDR_SUBNET
Network=  10.10.11.0
Netmask=  255.255.255.0

[VPN-22]
Phase=   2
ISAKMP-peer=  VPN-11
Configuration=  Default-quick-mode
Local-ID=  Net-local-02
Remote-ID= Net-remote-02

[Net-local-02]
ID-type=  IPV4_ADDR_SUBNET
Network=  192.168.100.0
Netmask=  255.255.255.0

[Net-remote-02]
ID-type=  IPV4_ADDR_SUBNET
Network=  172.30.1.0
Netmask=  255.255.255.0


Is it correct? It seems not work fine. Any ideas will be appreciated.

Thanks a lot!

Jack