Boot Problems - Intel PRO 1000XT

["Jonathan Liversidge" <jonathan.liversidge@monaghans.co.uk>]

Hi

I have just purchased the OpenBSD 3.1 CD and am attempting to install it
onto a Dell PowerEdge 1650.
The Dell has 2 x Embedded Intel PRO 1000XT (82544EI) NIC's.
However, the system hangs whem booting from the CD at the same point every
time with the following output:
------------------->snip<-------------------------
> gx2 at pci2 dev 2 function 0 "Intel PRO 1000XT (82544EI_CU)" rev 0x02:
can't map mem space
> fatal page fault in supervisor mode
> trap type 6 code 0 eip e0271b07 cs 8 eflags 10283 cr2 8 cpl 80
> panic: trap type 6, code=0, pc=e0271b07
>
> The operating system has halted.
> Please press any key to reboot.

There is also an Intel PRO 100 NIC that it seems to be happy with.
When I disable the 2 Intel PRO 1000XT's the system boots fine and allows
configuration of the single PRO 100.
If I disable just one of the 1000TX'x, the same error message as above
appears, just with "pci1".

I hope this is enough information and that somebody out there has a solution
to this problem.

Any help would be greatly appreciated.

Regards

Jonathan Liversidge