Re: snapshot booting problem for spar64

["Berk D. Demir" <bdd@ieee.org>]

On Tue, Jun 03, 2003 at 09:43:17AM +0100, Andrew Basterfield wrote:
> then I think we need that dmesg

OK then,
Here it comes.
---
console is keyboard/display
Copyright (c) 1982, 1986, 1989, 1991, 1993
	The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2003 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 3.3-current (GENERIC) #21: Sun Jun  1 19:19:40 MDT 2003
    deraadt@sparc64.openbsd.org:/usr/src/sys/arch/sparc64/compile/GENERIC
total memory = 134217728
avail memory = 115400704
using 819 buffers containing 6709248 bytes of memory
bootpath: /pci@1f,0/pci@1,1/ide@3,0/disk@0,0
mainbus0 (root): Sun Ultra 5/10 UPA/PCI (UltraSPARC-IIi 270MHz)
cpu0 at mainbus0: SUNW,UltraSPARC-IIi @ 270 MHz, version 0 FPU
cpu0: physical 32K instruction (32 b/l), 16K data (32 b/l), 256K external (64 b/l)
psycho0 at mainbus0 addr 0xfffc4000
SUNW,sabre: impl 0, version 0: ign 7c0 bus range 0 to 2; PCI bus 0
DVMA map: c0000000 to e0000000
IOTDB: 7c8000 to 848000
pci0 at psycho0
ppb0 at pci0 dev 1 function 1 "Sun Simba PCI-PCI" rev 0x11
pci1 at ppb0 bus 1
ebus0 at pci1 dev 1 function 0 "Sun PCIO Ebus2" rev 0x01
auxio0 at ebus0 addr 726000-726003, 728000-728003, 72a000-72a003, 72c000-72c003, 72f000-72f003
power at ebus0 addr 724000-724003 ipl 37 not configured
SUNW,pll at ebus0 addr 504000-504002 not configured
sab0 at ebus0 addr 400000-40007f ipl 43: rev 3.2
sabtty0 at sab0 port 0
sabtty1 at sab0 port 1
comkbd0 at ebus0 addr 3083f8-3083ff ipl 41: layout 34
wskbd0 at comkbd0: console keyboard
com0 at ebus0 addr 3062f8-3062ff ipl 42, mouse: ns16550a, 16 byte fifo
lpt0 at ebus0 addr 3043bc-3043cb, 30015c-30015d, 700000-70000f ipl 34: polled
fdthree at ebus0 addr 3023f0-3023f7, 706000-70600f, 720000-720003 ipl 39 not configured
clock0 at ebus0 addr 0-1fff: mk48t59: hostid 80a05253
flashprom at ebus0 addr 0-fffff not configured
audioce0 at ebus0 addr 200000-2000ff, 702000-70200f, 704000-70400f, 722000-722003 ipl 35 ipl 36: nvaddrs 0
audio0 at audioce0
hme0 at pci1 dev 1 function 1 "Sun HME" rev 0x01: address 08:00:20:a0:52:53
nsphy0 at hme0 phy 1: DP83840 10/100 media interface, rev. 1
hme0: using ivec 3021 for interrupt
vgafb0 at pci1 dev 2 function 0 "ATI Mach64 GT" rev 0x9a
wsdisplay0 at vgafb0: console (std, sun emulation), using wskbd0
pciide0 at pci1 dev 3 function 0 "CMD Technology PCI0646" rev 0x03: DMA, channel 0 configured to native-PCI, channel 1 configured to native-PCI
pciide0: using ivec 1820 for native-PCI interrupt
wd0 at pciide0 channel 0 drive 0: <ST34342A>
wd0: 16-sector PIO, LBA, 4103MB, 8894 cyl, 15 head, 63 sec, 8404830 sectors
wd1 at pciide0 channel 0 drive 1: <Maxtor 32049H2>
wd1: 16-sector PIO, LBA, 19541MB, 16383 cyl, 16 head, 63 sec, 40021632 sectors
wd0(pciide0:0:0): using PIO mode 4, DMA mode 2
wd1(pciide0:0:1): using PIO mode 4, DMA mode 2
atapiscsi0 at pciide0 channel 1 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <GoldStar, CD-ROM CRD-8240B, 1.24> SCSI0 5/cdrom removable
cd0(pciide0:1:0): using PIO mode 4, DMA mode 2
ppb1 at pci0 dev 1 function 0 "Sun Simba PCI-PCI" rev 0x11
pci2 at ppb1 bus 2
siop0 at pci2 dev 1 function 0 "Symbios Logic 53c875" rev 0x14 using on-board RAM ivec 10
scsibus1 at siop0: 16 targets
siop1 at pci2 dev 1 function 1 "Symbios Logic 53c875" rev 0x14 using on-board RAM ivec 11
scsibus2 at siop1: 16 targets
pcons at mainbus0 not configured
No counter-timer -- using %tick at 270MHz as system clock.
root on wd0a
rootdev=0xc00 rrootdev=0x1a00 rawdev=0x1a02
hme0: DAD detected duplicate IPv6 address fe80:0001::0a00:20ff:fea0:5253: NS in/out=1/1, NA in=0
hme0: DAD complete for fe80:0001::0a00:20ff:fea0:5253 - duplicate found
hme0: manual intervention required
---