[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
- To: ports_(_at_)_openbsd_(_dot_)_org
- Subject: clamav install
- From: "Allan P. Magmanlac" <allan_(_dot_)_magmanlac_(_at_)_nrns_(_dot_)_ca>
- Date: Tue, 08 Feb 2005 15:39:07 -0500
has someone able to properly install and run clamav from source?
I've been trying to build clamav-0.81 source in an openbsd 3.5 system. I
am able to
configure it fine and do a make and make install. However, after the
and clamdscan are not actually installed. It's not evident in the
config.status what went wrong.
The only installed binary is clamscan. Any ideas?
Visit your host, monkey.org